Infrastructure protectionBetter building design, maintenance would cut building sector’s emissions by around 80%

Published 5 June 2014

The construction industry, which uses half of the 1.5 billion tons of steel produced each year, could slash its carbon emissions by as much as 50 percent by optimizing the design of new buildings, which currently use double the amount of steel and concrete required by safety codes. If buildings are also maintained for their full design life and not replaced early, the sector’s emissions could in total be cut by around 80 percent.

The construction industry, which uses half of the 1.5 billion tons of steel produced each year, could drastically reduce its carbon footprint by optimizing the design of new buildings. Smart design could slash the sector’s carbon emissions by around 50 percent, without any impact on safety. If buildings are also maintained for their full design life and not replaced early, the sector’s emissions could in total be cut by around 80 percent — the target set in the U.K.’s 2008 Climate Change Act.

A University of Cambridge release reports that new research from the university has found that the amount of steel used by the construction industry, and the resulting carbon emissions, could be significantly lowered by optimizing the design of new buildings in order to use less material.

At present, in order to keep labor costs down, the construction industry regularly uses double the material required by safety codes. Analysis of more than 10,000 structural steel beams in twenty-three buildings from across the United Kingdom found that on average, the beams were only carrying half the load they were designed for. The results are published in the 4 June issue of the journal Proceedings of the Royal Society A.

Over one-quarter of the steel produced each year is used in the construction of buildings. Demand for steel is increasing rapidly, especially in the developing world, and is expected to double in the coming decades.

The iron and steel industry contributes nearly 10 percent of total global carbon emissions, which climate change experts recommend be halved by 2050. Coupled with skyrocketing demand from the developing world, drastic action is required if a reduction in the sector’s carbon footprint is to be achieved.

One option to achieve this reduction is by designing and building more efficiently, delivering the same performance from buildings but with less steel, but this is not common practice at present.

“Structural engineers do not usually design optimized structures because it would take too much time; instead they use repetition to decrease the cost of construction,” said Dr. Julian Allwood of the Department of Engineering, who led the research, which was funded by the U.K.’s Engineering and Physical Science Research Council (EPSRC). “This leads to the specification of larger steel components than are required.”

The researchers found that building designs are exceeding Eurocode Safety Standards by a factor of two and so are unnecessarily using double the amount of steel and concrete needed.

“As materials are cheap and structural design time is expensive, it is currently cheaper to complete a design by using safe but considerably over-specified materials,” said Dr. Allwood.

Additionally, many buildings are being designed to last for 100 years but on average are replaced after just forty.

By designing for minimum material rather than minimum cost, steel use in buildings could be drastically reduced, leading to an equivalent reduction in carbon emissions, at relatively low cost. The net result of avoiding over-design and early replacement is that the U.K. could provide the same amount of built space with just 20 percent of the materials — and therefore 20 percent of the carbon emissions - used at present.

“We need to see a more sensible use of materials in the construction sector if we are to meet carbon reduction targets, regardless of the energy mix used in manufacturing the materials,” said Dr. Allwood.

— Read more in Muiris C. Moynihan and Julian M. Allwood, “Utilization of structural steel in buildings,” Proceedings of the Royal Society A (4 June 2014) (doi: 10.1098/rspa.2014.0170)